BENDIX EC-30 ECU Instruções de instalação - Página 3

Procurar online ou descarregar pdf Instruções de instalação para Controlador BENDIX EC-30 ECU. BENDIX EC-30 ECU 3 páginas. Replacement kit

Imprimir página

GENERAL SAFETY GUIDELINES

WARNING! PLEASE READ AND FOLLOW

T H E S E I N S T R U C T I O N S T O AV O I D

PERSONAL INJURY OR DEATH:

When working on or around a vehicle, the following

general precautions should be observed at all times.

1. Park the vehicle on a level surface, apply the

parking brakes, and always block the wheels.

Always wear safety glasses.

2. Stop the engine and remove ignition key when

working under or around the vehicle. When

working in the engine compartment, the engine

should be shut off and the ignition key should

be removed. Where circumstances require that

the engine be in operation, EXTREME CAUTION

should be used to prevent personal injury resulting

from contact with moving, rotating, leaking, heated

or electrically charged components.

3. Do not attempt to install, remove, disassemble

or assemble a component until you have read

and thoroughly understand the recommended

procedures. Use only the proper tools and

observe all precautions pertaining to use of those

tools.

4. If the work is being performed on the vehicle's

air brake system, or any auxiliary pressurized air

systems, make certain to drain the air pressure

from all reservoirs before beginning ANY work

on the vehicle. If the vehicle is equipped with

an AD-IS

air dryer system or a dryer reservoir

module, be sure to drain the purge reservoir.

5. Following the vehicle manufacturer's recommended

procedures, deactivate the electrical system in a

manner that safely removes all electrical power from

the vehicle.

6. Never exceed manufacturer 's recommended

pressures.

7. Never connect or disconnect a hose or line containing

pressure; it may whip. Never remove a component

or plug unless you are certain all system pressure

has been depleted.

8. Use only genuine Bendix

components and kits. Replacement hardware,

tubing, hose, ﬁ ttings, etc. must be of equivalent

size, type and strength as original equipment and

be designed speciﬁ cally for such applications and

systems.

9. Components with stripped threads or damaged

parts should be replaced rather than repaired. Do

not attempt repairs requiring machining or welding

unless specifically stated and approved by the

vehicle and component manufacturer.

10. Prior to returning the vehicle to service, make certain

all components and systems are restored to their

proper operating condition.

11. For vehicles with Automatic Traction Control (ATC),

the ATC function must be disabled (ATC indicator

lamp should be ON) prior to performing any vehicle

maintenance where one or more wheels on a drive

axle are lifted off the ground and moving.

replacement parts,