Airwell RC5 Manual - Página 3

Procurar online ou descarregar pdf Manual para Controlo remoto Airwell RC5. Airwell RC5 8 páginas. For room air conditioner
Também para Airwell RC5: Manual de programação e operações (11 páginas)

Imprimir página

USING THE REMOTE CONTROL UNIT

HOW TO INSTALL BATTERIES

Remove the lid in the rear part of the remote

control unit.

Insert two AAA alkaline batteries of 1,5 V-DC.

Make sure the batteries point in the direction

marked in the battery compartment.

The batteries last about six months. Depending

on how much you use the remote control unit.

Remove the batteries if you do not use the

remote control unit for more than one month.

Press the +, -, SET and CLEAR buttons

together after batteries replacement.

(This operation allows you to reset correctly all

the programs. The remote control unit is to be

set up again).

Replace the batteries when the remote

control unit lamp fails to light, or when the air

conditioner does not receive the remote control

unit signals.

The batteries of the remote control contain

polluted substances exhausted batteries must

be disposed according to the laws in force.

NOTE

The remote control unit sends the temperature signal to the air

conditioner regularly at two minute intervals. If the signal from

he remote control unit stops for more than five minutes due to

some troubles, the air conditioner will switch to the temperature

ensor which is built into the indoor unit and controls the room

temperature. In these cases, the temperature around the remote

control unit may differ from the temperature detected in the air

conditioner position.

OPERATION WITH THE REMOTE CONTROL UNIT

Check that the circuit breaker on the power

panel is turned ON and the STANDBY lamp is

light up.

When using the remote control unit, always

point the unit transmitter head directly at the air

conditioner receiver.

HOW TO TURN ON THE AIR CONDITIONER

Press the ON/OFF button to turn the air

conditioner on. The indicator OPERATION will

light up, indicating the unit is in operation.

REMOTE CONTROL

UNIT DISPLAY