dymax PC-3 Manual de operação - Página 9

Procurar online ou descarregar pdf Manual de operação para Equipamento de iluminação dymax PC-3. dymax PC-3 16 páginas. Ultra uv curing light source
Também para dymax PC-3: Manual de operação (20 páginas)

Imprimir página

1. Install lamp per LAMP REPLACEMENT/INSTALLATION.

2. Connect power cord to rear of unit and plug into a grounded wall outlet.

3. Connect light guide to bezel mount by inserting and snapping into place.

4. Toggle lamp switch to ON (1).

5. Allow lamp to warm up for 4-5 minutes to obtain maximum light output.

6. Locate foot switch where desired; connect to foot pedal outlet.

7. Operate shutter by pressing foot switch. With the shutter selector switch in the

manual position, the shutter operates directly from the foot switch. In the timed

position, the shutter opening is determined by the setting on the digital display on the

left side of the front panel. Simply push the + or - buttons to enter the desired

number of seconds the shutter is to remain open.

THIS IS AN ARC, NOT A FILAMENT LAMP. ONCE IGNITED, IT MUST BE LEFT ON

FOR A MINIMUM OF 5 MINUTES TO FULLY VAPORIZE ELEMENTS IN THE LAMP.

IF NOT, THE LAMP MAY BE DIFFICULT TO REIGNITE.

The lamp must cool before it can be reignited. Leave power switch on should the lamp

extinguish. This operates the cooling fan and allows the lamp to relight when it has

cooled sufficiently. If the lamp fails to ignite, refer to the TROUBLESHOOTING section

of this manual. Lamp life is reduced approximately one hour each time the lamp is

switched on and off. Avoid repeated cycles by leaving unit on through breaks.

TM-023 PN 37099

Rev 05/12/98

CAUTION

NOTE