dymax ACCU-CAL 50-LED Manual do utilizador - Página 11
Procurar online ou descarregar pdf Manual do utilizador para Instrumentos de medição dymax ACCU-CAL 50-LED. dymax ACCU-CAL 50-LED 16 páginas. Led radiometer
Imprimir página
6.
Press and release the Light Source Button to select the light source being measured. For the BlueWave QX4, use the
"spot" setting. Repeatedly press the Light Source Button until the correct focus lens size appears on the top line. The
options are:
•
3-mm Spot - For use when measuring a BlueWave QX4 LED head with the 3-mm focus lens installed
•
5-mm Spot - For use when measuring a BlueWave QX4 LED head with the 5-mm focus lens installed
•
8-mm Spot - For use when measuring a BlueWave QX4 LED head with the 8-mm focus lens installed
Figure 18.
Spot Mode Screens (Shown in Peak Intensity Mode)
7.
Press and release the Mode button to select the operating mode. The different operating modes are:
•
Peak Intensity - Shows the highest intensity in mW/cm
that value in the display.
•
Intensity - Shows the intensity in mW/cm
intensity.
•
Dose - Shows the total energy dose in mJ/cm
Note: This measurement is time dependent
8.
Turn on the BlueWave QX4 to begin testing.
U S E R G U I D E
A C C U - C A L ™ 5 0 - L E D R A D I O M E T E R
|
seen by the detector during the measurement and stores
2
2
at the detector during the measurement. This is a dynamic readout of
2
at the detector during the measurement.
.
11