Benedini TBS Mini Manual - Página 6

Procurar online ou descarregar pdf Manual para Equipamento de gravação Benedini TBS Mini. Benedini TBS Mini 11 páginas. Digital multifunctional rc-soundunit
Também para Benedini TBS Mini: Manual (11 páginas), Manual de dados técnicos (11 páginas)

Imprimir página

The installation of the encoder in your transmitter is on your own risk

Proper functionality is not guaranteed at ALL transmitter brands / types

3.1.1. Push button encoder

A simple resistor array combined with some push buttons can be also used to control the

soundunit. This is only a suggestion and needs to be build by your own:

390

R12

5k6

You should check the operation by a common servo. Adjust the min. and max. travel range with

the potentiometers P1 and P2 in comparison to the travel at a common joystick channel(f.e.Ch1).

The installation of this circuit in your transmitter is on your own risk

Proper functionality is not guaranteed at ALL transmitter brands / types

3.1.2. Teaching the sound unit for encoder control

1) Power transmitter and receiver. LED blinks fast -> normal mode

Bring all joysticks to neutral position. Model must not move.

2) Press the TEACH. button until one beep occurs -> LED cont. lit.

At this moment all neutral / idle positions are stored.

3) Move throttle stick to your desired acceleration point (throttle stick position where

engine idle sound changes to moving sound) and push the button of the encoder.

-> A short sequence of acceleration is played

4) Move throttle stick to full speed and push the encoder button again

A short sequence of full speed is played.

5) Bring the encoder rotary switch to its first position and push the encoder button

-> Engine start/stop is stored to this position

Hint: The rotary switch has no mechanical limits. You can define any position as the

"first" one.

6) Bring the encoder rotary switch to the next position, wait about 2s and push the

encoder button again.

-> Reeving up the engine is stored to this position

7) Repeat step 6 until all 12 rotary switch positions are stored

8) After teaching all positions the sound unit beeps 3x and is back in normal operation

mode.

Hint:

If you are using the resistor network shown above instead of the encoder, each rotary switch

position is represented by one of the push buttons.

TBS Mini, 05/2016

390

820

ST1

Zum Sender

www.benedini.de

R10

R11

390

S10

S11

S12

Page 6 of 11

R13

5k6