Dymo Rhino M1011 Manual do utilizador - Página 12

Procurar online ou descarregar pdf Manual do utilizador para Fabricante de etiquetas Dymo Rhino M1011. Dymo Rhino M1011 16 páginas. Rhino

Punching Holes in Non-Adhesive Labels

You can choose to punch one or two holes in non-adhesive labels so that

the labels can be attached using screws, nails, rivets, and metal or plastic

wires or ties. You can also punch a cable tie slot in one or both ends of the

label.

To punch a hole

1. Insert one end of the cut label into the hole punch slot (L).

2. Lift the cutting handle (I) to the vertical position to punch a hole.

To punch a cable tie slot

1. Insert one end of the cut label into the cable tie slot (K) with the

letters facing down. The letters must face down to ensure the bridge

of the slot is on the same side of the label as the characters.

Make sure to allow enough room for the tie-buckle before

and/or after the letters. A cable tie slot positioned on top of the

characters or a punched hole may cause the tape to jam.

2. Lift the cutting handle (I) to the vertical position to punch the slot.