Gage Bilt GB730 Manual de instalação - Página 10

Procurar online ou descarregar pdf Manual de instalação para Ferramentas Gage Bilt GB730. Gage Bilt GB730 14 páginas. Installation tool
Também para Gage Bilt GB730: Manual do utilizador (13 páginas)

Imprimir página
Gage Bilt GB730 Manual de instalação
HEAD
WARNING:
Dispose of hydraulic oil in accordance with all environmental regulations applicable in your area.
Remove nose assembly from tool before attempting disassembly of head cylinder assy.
Remove end cap (730717). Push against threaded end of piston (730311) to slide it out of head cylinder (730398). Be careful not to
damage threads or cause burrs on polished piston (730311) surface.
The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque
the four button-head cap screws (A-928) uniformly to 40 inch lbs. to prevent leakage around the gasket (745124).
WARNING:
This tool incorporates a patented hydraulic relief valve. When overhauling tool, o'ring (S829), back-up ring
(401084), retaining ring (400935) and spring (50806) must be replaced. Failure to do so could result in SEVERE
PERSONAL INJURY!
S/N: 2317 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
O'RING - S829
BACK - UP RING - 401084
SPRING - 50806
RETAINING RING - 400935
10
PISTON ROD ASSY. - 730233
Rev. 2/15