Gage Bilt GB7720 Informações sobre a ferramenta de instalação - Página 5

Procurar online ou descarregar pdf Informações sobre a ferramenta de instalação para Ferramentas Gage Bilt GB7720. Gage Bilt GB7720 10 páginas. Hydraulic installation tool
Também para Gage Bilt GB7720: Manual (9 páginas)

Imprimir página

MAINTENANCE

WARNING:

EXCESSIVE CONTACT WITH HYDRAULIC OIL AND LUBRICANTS SHOULD BE AVOIDED.

WARNING:

MAINTENANCE PERSONNEL

WARNING:

DISPOSE OF HYDRAULIC OIL IN ACCORDANCE WITH ALL ENVIRONMENTAL LAWS AND

REGULATIONS APPLICABLE TO YOUR AREA.

WARNING:

DISCONNECT TOOL FROM ITS POWER SOURCE BEFORE DISASSEMBLY.

WARNING:

WHEN TIGHTENING OR LOOSENING HYDRAULIC HOSES, USE A 9/16" WRENCH TO HOLD THE

HYDRAULIC FITTING TO PREVENT THE STEEL TUBE FROM TWISTING. TWISTING THE STEEL

TUBE CAN CAUSE PREMATURE FAILURE AT WELDED JOINTS.

WARNING:

BE SURE POWERUNIT IS DISCONNECTED BEFORE CLEANING, OR WHEN REPLACING WORN OR

DAMAGED COMPONENTS. SEVERE PERSONAL INJURY MAY OCCUR IF POWER SOURCE IS NOT

DISCONNECTED.

The performance of any tool depends upon good maintenance practices. Following these minimal requirements for ser-

vice and care will extend the life of your tool.

*Only use a hydraulic power source equipped with relief valves and pressures set within specified lim

its. Consult Powerunit Manual for procedure to set PULL and RETURN pressures.

*Keep hydraulic system free of dirt. Avoid letting couplers contact a dirty floor.

*Do not use as a hammer to force fasteners into holes or otherwise abuse tool.

*Proper care by operators is necessary in maintaining full productivity and reducing down time.

* Check tool, all hoses and all couplings daily for damage or air/hydraulic leaks. Tighten or replace (if

necessary). (See hydraulic thread preparation pg.5)

HYDRAULIC THREAD PREPARATION

WARNING:

WHEN TIGHTENING OR LOOSENING HYDRAULIC HOSES, USE A 9/16" WRENCH TO HOLD THE

HYDRAULIC FITTING TO PREVENT THE STEEL TUBE FROM TWISTING. TWISTING THE STEEL

TUBE CAN CAUSE PREMATURE FAILURE AT WELDED JOINTS.

IMPORTANT:

Be sure to use thread sealant on all hydraulic fittings, Loctite® 30534 or similar Teflon® infused pipe

dope is recommended.

properly applied, pieces of Teflon may enter the hydraulic system and cause malfunction or damage.

Use 1 1/2 wraps of tape on each thread. Cut off all loose tape ends. Tighten until fitting feels snug and

then go 1/2 to a full turn past that point.

S/N: 1004 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

MUST

READ AND UNDERSTAND ALL WARNINGS AND CAUTIONS.

CAUTION:

Teflon tape is an excellent thread sealer, however, if it is not

CAUTION:

Over tightening can easily distort the threads.

Rev. 6/14