Gage Bilt GB703 Manual de instalação - Página 9

Procurar online ou descarregar pdf Manual de instalação para Ferramenta eléctrica Gage Bilt GB703. Gage Bilt GB703 20 páginas.

Imprimir página
Gage Bilt GB703 Manual de instalação
WARNING:
Only qualified and trained operators should install, adjust or use the assembly power tool for non-threaded
mechanical fasteners.
WARNING:
Operator
WARNING:
It is required that eye protection, hearing protection and safety boots be worn at all times while handling this
equipment.
WARNING:
The users or the user's employer should assess specific risks that could be present as a result after each use
based on their application.
● Be sure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of
any moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.
● Verify
●
Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool
WARNING:
Do not pull rivet in the air. Personal injury from fastener ejecting may occur.
WARNING:
Air is exhausted from the bottom of the tool. Direct bottom of the tool (exhausted air) away from operator, other
persons working in the vicinity, foreign matter and liquid.
WARNING:
Do not carry from hoses or use as a hammer.
WARNING:
Do not use in explosive atmosphere.
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping.
WARNING:
Always disconnect air supply when tool is not in use to prevent accidental start-up.
WARNING:
Be sure there is adequate clearance for tool and operator hands.
CAUTION:
Do not use beyond the design intent.
S/N: 3191 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

HOW TO USE THE GB703

MUST
read and understand all warnings and cautions.
the air lines and/or hydraulic hoses are not a trip hazard.
Blind Fasteners
1.
Insert fastener.
2.
Insert rivet into nose assembly.
3.
Press actuator to start cycle.
4.
Release actuator as soon as fastener breaks.
5.
Repeat steps 1-4.
Images may not reflect actual tool or fastener
9
4/12 Rev. 1/17