Gage Bilt GB752 Informações sobre a ferramenta de instalação - Página 8
Procurar online ou descarregar pdf Informações sobre a ferramenta de instalação para Ferramentas de rebitar Gage Bilt GB752. Gage Bilt GB752 12 páginas.
Também para Gage Bilt GB752: Manual de instruções original (20 páginas), Informações sobre a ferramenta de instalação (13 páginas)
Imprimir página
OVERHAUL
The disassembly and re-assembly procedure can be accomplished by utilizing the following instructions and drawings. Use extreme
care during disassembly and re-assembly not to mar or nick any smooth surface that comes in contact with seals. Before installing
seals, always apply a good lubricant, such as Lubriplate®, to the surfaces. It is recommended that tool kit (GB704TK) be used to
facilitate overhaul. A complete overhaul can be achieved by the use of Service Kit 752020 which contains a complete set of o'rings,
back-up rings, screws, washers and gasket. It is recommended that this service kit be kept available for spare parts.
WARNING:
DEPRESS TRIGGER AND DISCONNECT FROM AIR WITH HEAD PISTON IN THE REAR POSITION BEFORE
OVERHAUL. SEVERE PERSONAL INJURY MAY OCCUR IF AIR HOSE IS NOT DISCONNECTED.
WHEN FORCING PISTON ROD ASSEMBLY DOWNWARD WITH HEAD CYLINDER ASSEMBLY REMOVED,
HYDRAULIC FLUID WILL EJECT FORCIBLY FROM HANDLE.
704214
STEM CATCHER BAG
HEAD
Remove nose assembly and adapter from tool before attempting disassembly of head assembly.
Remove end cap (752313). Push against threaded end of head piston (752507) to slide it out of head cylinder (752119). Be careful not
to damage threads or cause burrs on polished piston rod surface.
WARNING:
DISPOSE OF HYDRAULIC FLUID IN ACCORDANCE WITH ALL ENVIRONMENTAL LAWS AND REGULATIONS
APPLICABLE IN YOUR AREA.
The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque
the button head cap screws (A-928) uniformly to 40 inch lbs. to prevent leakage around the gasket.
752301
NOSE FITTING
211102 - NUT
240102
RETAINING NUT STOP
704151
POWER CYLINDER TOOL
704149
PISTON ROD WRENCH
(704214 CATCHER BAG AS SHOWN ABOVE IS SOLD SEPARATELY.)
GB704TK Service Tool Kit Includes:
Part No.
704149
704150
704151
704152
704153
S1178
704162
704163
401089
BACK-UP RING
752119
HEAD CYLINDER
STAT-O-SEAL
ASSEMBLY
704152
SEAL GUIDE
704150
PACKING PLUG WRENCH
BLEEDER BOTTLE
Description
Piston Rod Wrench
Packing Plug Wrench
Power Cylinder Tool
Seal Guide
Bleeder Bottle
Valve Extractor
Valve Spring Installation Tool
Valve Sleeve Removal Tool
A-1134
POLYSEAL
(O'RING IN POLSYSEAL
MUST FACE IN
THIS DIRECTION)
200506-2 - PINTAIL TUBE
(FOR USE WITH BLIND RIVETS SMALL THAN 3/16" Ø)
S834 - O'RING
S834 - O'RING
402482 - BUTTON
HEAD CAP
SCREW
S572
8
704162
VALVE SPRING
INSTALLATION TOOL
704163
704153
VALVE SLEEVE
REMOVAL TOOL
400793
O'RING
S829 - O'RING
400791 - O'RING
752507 - PISTON
USE CAUTION
S1178
VALVE EXTRACTOR
752122
DEFLECTOR
752313 - CAP
REV. 4/13