Gage Bilt GB808 Manual de instruções original - Página 8
Procurar online ou descarregar pdf Manual de instruções original para Gerador portátil Gage Bilt GB808. Gage Bilt GB808 20 páginas.
Imprimir página
WARNING:
Only qualified and trained operators shall install, adjust or use the assembly power tool for non-threaded
mechanical fasteners.
WARNING:
Operator
WARNING:
It is required that eye protection, hearing protection and foot protection be worn during operation.
WARNING:
The users or the user's employer must assess specific risks that could be present as a result after each use
based on their application.
● Ensure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of
any moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.
● Verify that hydraulic hose fittings and couplings, air and electrical connections are secure.
● Verify
●
Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool
●
Do not use as a hammer to force fasteners into holes or otherwise abuse tool.
WARNING:
Do not actuate fastener in the air. Personal injury from fastener ejecting may occur.
WARNING:
Do not use in explosive atmosphere.
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping.
WARNING:
Always disconnect air supply when tool is not in use to prevent accidental start-up.
CAUTION:
Do not use beyond the design intent.
The tool is shipped with a red plastic plug in the air inlet connector. The connector has a 1/4-18 NPT female pipe thread to accept end-
user air hose fitting. The tool comes with oil and is ready to use.
1. Remove red plastic shipping plug from air inlet on regulator (A-1291) and screw in your quick disconnect (air) fitting.
2. Open cap on top of oil reservoir and fill with AW-32® oil or equivalent to approximately 3/4 full, if required.
3. Connect the installation tools hydraulic line, air line, and lanyard to powerunit. (Make sure all connections are secure).
4. Connect air supply using 1/2" (12.7 mm) air line min. Set air pressure to 80-100 P.S.I. (5.5-6.9 bar) Max. on (A-1291) regulator.
5. Cycle tool five times.
6. See tool manual for complete set up installation instructions.
Red Shipping Plug
User Quick Disconnect Fitting
Air Hose
GB808 POWERUNIT
HOW TO SET-UP THE GB808 SERIES POWER UNIT
MUST
read and understand all warnings and cautions.
the air lines and/or hydraulic hoses are not a trip hazard.
Pop Safety Valve
Air Filter/ Regulator
Air Inlet
Powerunit shown without frame assembly
Images may not reflect actual tool
Open oil reservoir
cap & fill reservoir
Four-Way Valve
PULL/RETURN
Booster Assembly
8
Install air lines from tool into
A-577 & A-579 on powerunit.
Hydraulic
oil reservoir
Install hydraulic coupler-male
from tool into hydraulic coupler-
female on power unit
Hydraulic oil flows from booster
assembly thru hydraulic line into tool
12/21 REV 4/22