Gaggenau 400 Series Manual de utilização e cuidados - Página 15
Procurar online ou descarregar pdf Manual de utilização e cuidados para Forno Gaggenau 400 Series. Gaggenau 400 Series 18 páginas. Vacuuming drawer
Também para Gaggenau 400 Series: Manual de início rápido (2 páginas), Manual de início rápido (2 páginas), Manual de início rápido (2 páginas)
Imprimir página
Solutions to Common Dishwashing Problems
(continued)
Etching
• Using too much detergent in soft or
softened water causes this film that cannot
be removed.
• Adjust the amount of detergent based on
the water hardness. (Check Detergent
Chart.)
• Lower the water temperature.
• Use the Cool Dry option.
Detergent Left in Cups
•Detergent may be old. Discard and use fresh
detergent.
•Be sure water action can reach the dispenser.
•Check to see if cycle has been completed.
•Make sure items do not prevent the
detergent dispenser from opening.
Dishwasher Leaks
•Use only fresh detergent designed for
automatic dishwashers. Measure detergent
carefully. Try a different brand.
•Spilled rinse aid can cause foam and lead to
overflowing. Wipe up any spills with a damp
cloth.
•Check to see that dishwasher is level. (See
Installation Instructions.)
Normal Sounds You Will Hear
•Normal sounds include water fill, water
circulation and motor sounds.
•There is a noticeable change in sound when
the wash action switches between the lower
and middle spray arm. This is normal since
each spray arm has its own sound.
•It is normal for dishwasher to pause (no
sound) when the wash action is switching
between the lower and middle spray arms.
Water in Bottom of Tub
•Water left in bottom of tub after cycle is
complete is not normal. If water remains in
the bottom of the tub, dishwasher may not
be draining properly. (See Dishwasher Does
Not Drain Properly.)
Vapor at Vent
•Water vapor escapes from the vent when the
dishwasher goes into the drying part of
cycle. This is normal.
Dishwasher Won't Run
•Check to see if circuit breaker is tripped or if a
fuse is blown.
•Make sure water supply is turned on.
•Check to see if cycle is set correctly. (See
Operating Instructions.)
•Is dishwasher set for delay start option?
•Make sure door is closed and latched.
Dishwasher Does Not Drain Properly
• If unit is hooked up to a food waste disposer,
make sure the disposer is empty.
• Check to see if the knockout plug has been
removed from inside the food waste disposer
inlet.
• Check to see if drain hose is kinked.
• Make sure cycle is complete, not in a pause.
Cycle Takes a Long Time
• Is cycle in a water heating delay?
• Has the delay start option been selected?
Dishwasher Won't Fill
• Is water supply turned on?
• Does overfill protector move up and down
freely? (See Overfill Protector section.)
Dishwasher Has an Odor
• Soiled dishes left in dishwasher too long can
create an odor. Use Rinse/Hold cycle.
• There will be a "new" smell when first
installed. This is normal.
• Check to see if unit is draining properly. (See
Dishwasher Does Not Drain Properly.)
Stains on Tub Interior
• Washing large amounts of dishware with
tomato based soil can cause a pink/orange
appearance. This will not affect performance
and will gradually fade over time. Pre-rinsing
or using the Rinse/Hold cycle will reduce the
chance of staining. Using Cool Dry option
will lessen staining.
15