Active Silicon HARRIER 3G-SDI CAMERA INTERFACE BOARD Manual de início rápido - Página 8
Procurar online ou descarregar pdf Manual de início rápido para Hardware informático Active Silicon HARRIER 3G-SDI CAMERA INTERFACE BOARD. Active Silicon HARRIER 3G-SDI CAMERA INTERFACE BOARD 8 páginas.
Imprimir página
Reset Button
Pressing this button on the Harrier Evaluation Board causes the camera interface board and camera
to reset. Some features require a camera reset to activate/complete certain VISCA commands.
Note: this button will only work if the 4-way cable is connected between the Harrier Evaluation Board
(J102) and the camera interface board (J2).
Analog Video Output
The BNC connector on the Harrier Evaluation Board will supply the analog video output of the
camera interface board. The Harrier 3G-SDI Camera Interface Board generates the analog signal by
downscaling the camera digital output. To enable this, the camera must be set into 720p50/720p60
output mode. By default, when this camera video mode is set, both analog and digital outputs are
enabled. A VISCA command can be used to select 4:3 or 16:9 analog output modes.
Technical Support
In case of any issues, please contact Active Silicon Technical Support on the telephone numbers
below or by email to [email protected].
Europe & APAC:
Active Silicon Ltd
Pinewood Mews, Bond Close, Iver,
Bucks, SL0 0NA, UK.
Tel:
+44 (0)1753 650600
Fax:
+44 (0)1753 651661
Email
Website:
www.activesilicon.com
September 2020, ASL
September 2020
HARRIER 3G-SDI CAMERA INTERFACE BOARD
Americas:
Active Silicon, Inc.
479 Jumpers Hole Road, Suite 301,
Severna Park, MD 21146, USA.
Tel:
Fax:
Email:
Website:
QUICK START GUIDE
Version 1.2.AS - September 2020
+1 410-696-7642
+1 410-696-7643
www.activesilicon.com
Page 8 of 8