Aircommand IBIS Manual de instruções de instalação e funcionamento - Página 14
Procurar online ou descarregar pdf Manual de instruções de instalação e funcionamento para Ar condicionado Aircommand IBIS. Aircommand IBIS 15 páginas.
Imprimir página
OPERATING INSTRUCTIONS
- Turn the unit on by pressing the ON/OFF button once.
- Press the MODE button to cycle through options Cool,
Dry, Heat and Fan.
COOLING
- Cycle mode button to highlight COOL.
- You may select High, Med, Low or Auto fan speeds by
pressing the fan button. It is recommenced that you choose
Auto.
- Now select the desired room temperature (herein referred
to as SETPOINT) by pressing the TEMP up or down keys,
the readout will flash the set point temperature. Keep
pressing the button until it flashes your desired set point. In
approx. 5 seconds the display will resume reading the actual
room temperature. The compressor will have a delayed start
usually 3 minutes before unit starts to cool.
N.B: Any interruption to the power supply will cause the unit
to delay compressor start up.
- For simply recirculating air, choose the FAN mode.
Choose any of the three fan speeds by pressing FAN button.
N.B: Temperature button is invalid in Fan only mode.
HEAT
- To heat, press MODE button to highlight HEAT.
- Select desired set point temperature by pressing TEMP buttons up or down. It is recommended that AUTO fan speed
by selected.
- After the delay, the compressor will start. Usually the fan will stop and will not re-energize until the heat exchanger
has warmed and then the fan will start to blow warm air.
DRY
- The DRY mode is used when the room temperature is close to comfortable but you wish to dehumidify.
- Press MODE button to highlight DRY.
- Set the temperature to desired set point. N.B: the fan speed is locked in LOW.
- The compressor will cycle on and off at approximate intervals of 6 minutes to extract moisture from the air.
SLEEP
- With the unit operating in cool mode, press sleep button to highlight the sleep light. The unit over the next hour will
automatically raise the set point by 1c. Conversely in heat mode, the set point will be lowered 1c.
- The TIMER may be used to turn off the unit in the future (up to 24 hours) OR may be used to turn on the unit up to
24 hours in the future.
- Press TIMER button once and the display will flash. Within 3 seconds, press the timer button until you have set
desired time into the future to turn unit off. A subsequent press of the timer button will allow the time to start the unit
to be programmed.
LOCKING
- This provides a means of locking in the mode and fan settings. To lock, press temp down key simultaneously with
MODE button. Hold for 3 seconds and the lock indicator will light. To unlock, repeat above procedure.
DISPLAY SETTING
- To change readout from Celsius to Fahrenheit or vice versa: Press temp down key simultaneously with the Fan key.