Gaggenau VG 425 111 IN Manual de instruções - Página 13
Procurar online ou descarregar pdf Manual de instruções para Hob Gaggenau VG 425 111 IN. Gaggenau VG 425 111 IN 16 páginas.
Imprimir página
Trouble shooting
M alfunctions often have simple explanations. Please
T r o u b l e s h o o t i n g
read the following notes before calling the after-sales
service.
Disruption
The burner will not ignite when it is
switched on.
The burner will not ignite when it is
switched on.
The illuminated ring behind the control
knob is flashing orange and white alter-
nately.
The burner will not ignite when it is
switched on.
All the illuminated rings behind the con-
trol knobs are lit white for 10 seconds
after switch-on. Then the illuminated ring
around the active control knob is lit
orange.
The burner will not ignite when it is
switched on.
The illuminated ring behind the control
knob is flashing yellow and magenta
alternately.
The burner goes out while the appliance
is in operation.
The illuminated ring behind the control
knob is flashing orange and white alter-
nately.
The burner goes out while the appliance
is in operation.
The illuminated ring behind the control
knob is flashing orange and white alter-
nately.
There is a smell of gas in the kitchen.
The appliance panelling becomes
slightly raised at the corners when it is in
operation.
--------
m
Incorrect repairs are dangerous. Repairs may only be
carried out by one of our trained after-sales engineers.
If the appliance is faulty, unplug the mains plug or
switch off the fuse in the fuse box. Contact the after-
sales service.
Possible cause
Power supply disconnected.
Burner or gas supply fault.
Demo mode is activated.
Electronics fault
Safety switch-off function:
No actions have been performed
for an extended period.
Domestic power failure:
Following a power failure, the
appliance will remain switched
off for safety reasons.
Gas may be leaking out where
the gas cylinder is connected.
The metal from which the cook-
top is made expands as it heats
up.
Warning – Risk of electric shock!
Solution
Turn all control knobs to 0. Check the fuse box to
see whether the circuit breaker has tripped.
Turn all control knobs to 0.
Check:
▯
Are the burner parts positioned correctly?
▯
Is the main gas tap open?
▯
Is the burner clean and dry?
▯
Is there air in the line following initial connection
or a cylinder change (in the case of liquid gas)?
▯
Is the gas cylinder empty (in the case of liquid
gas)?
Deactivate demo mode.
Turn all control knobs to 0 and disconnect the appli-
ance from the mains power supply for one minute
(switch off the circuit breaker or pull out the plug).
Reconnect the appliance. The illuminated rings
around the control knobs will be lit green for a few
seconds and then turn yellow. Wait until the illumi-
nated rings switch off. Then turn any of the control
knobs to any of the heat settings and then back to 0.
Switch on the burner. If the illuminated ring starts
flashing yellow and magenta again, call our after-
sales service.
Turn all control knobs to 0, and then switch them
back on if you wish to continue using the appliance.
Turn all control knobs to 0, and then switch them
back on if you wish to continue using the appliance.
Check that the gas cylinder connection is not leak-
ing. Open windows and ensure the room is well ven-
tilated.
This is normal. It will contract again once it has
cooled down.
Trouble shooting
en
13