GREAT PLAINS 3P1006NT Manual de ajuste de campo - Página 4
Procurar online ou descarregar pdf Manual de ajuste de campo para Equipamento agrícola GREAT PLAINS 3P1006NT. GREAT PLAINS 3P1006NT 4 páginas. 3-point eight & ten foot no-till drills
Imprimir página
T-Handle Adjustment:
The depth of each opener is controlled by the height of
the press wheel. Varying the height of the press wheel
changes the seeding depth of the opener. Moving the
"T" handle to the front of the opener shallows the
depth; moving the "T" handle towards the rear of the
opener increase the depth. For a starting point, place
the "T" handle towards the center.
Feed Cup Adjustment:
Each feed cup is equipped with a four-position adjust-
ment handle:
A) The highest position is for wheat and other small
grains
B) The second position is for soybeans and other large
grains
C) The third position is used if the seeds are cracking
in the second position
D) The bottom position is for clean out and will drain all
seed
Note: Do not open the feed cup handle to the bottom
position with seed in the box unless complete clean out
is desired. Changing this handle will change the seed-
ing rate. When storing after drilling season, it is best to
place the handle in the bottom position to prevent dam-
age from mice.
Selecting Drive Type:
The gearbox is designed to give a variety of drive
speeds for different types of seed and rates. It is a lin-
ear shaft pattern design with constant mesh gearing
and is totally sealed to keep any dirt out. No lubrication
is required unless service is needed.
1) To set the gearbox, simply move the selector handle
until the desired drive type appears in the window on
the handle:
Main Seed Box Drive Type Ratios
Drive Type 2 is 2.06 Times Faster Than 1
Drive Type 3 is 3.08 Times Faster Than 1
Drive Type 4 is 5.03 Times Faster Than 1
Document
#DRUS100C-0003A
48642
A
B
C
48509
48877
4 of 4
D