Hi-Tech Diamond All-U-Need Glass/Crystal Manual de instruções - Página 10

Procurar online ou descarregar pdf Manual de instruções para Lixadeira Hi-Tech Diamond All-U-Need Glass/Crystal. Hi-Tech Diamond All-U-Need Glass/Crystal 16 páginas.

Imprimir página

OILING

The only part you need to oil on the All-U-Need

machine is the inside of the 2" silver arbor. This is

required because the motor shaft and arbor are

made of different materials. Over time, they can

seize together, making it impossible to remove

the arbor. Every two months or so, remove the

arbor by inserting the included Allen wrench into

the set screw, turning counter-clockwise. Turn the

arbor upside down. Apply a few drops of motor

oil, way oil, lithium or water pump grease into

the area where the arbor fits onto the shaft. Make

sure there is no excess oil so that oil doesn't drip

down the motor shaft and get into the motor.

This will cause an instant motor burn-out. When

putting the arbor back onto the shaft, make sure

the screw is positioned against the flat side of the

motor shaft. If the screw is positioned against the

rounded side of the shaft, it will make a squeak-

ing noise and create friction, causing the motor

shaft to get hot. Once the arbor is positioned

properly, check the set screw for tightness on the

arbor using the Allen wrench. Do not over tighten

the set screw, as you will need to remove it regu-

larly to clean the tray. The arbor may be adjusted

up and down if necessary to keep the spinning

disc below the black spray shield.

Set

screw

MAINTENANCE

Arbor

CLEANING

The All-U-Need is designed to be easily disas-

sembled for cleaning. After each use, rinse the

black splash guard and flush out the white catch

tray with clean water so the rock sediment can

get washed down the drain tube. Any used water

must not be disposed down a sink, as it can

harden like cement, closing off the drain. Allow

the machine to dry completely then store it in a

safe place, away from children.

Note: When you are finished using the diamond lap

disc and diamond smoothing discs, rinse and spin

completely dry. Store them in a clean, dry plastic

bag until next use. The maximum weight of any

discs/laps should not exceed 1.5lbs on your All-U-

Need machine.

FUSE DETAILS

The fuse is installed in the back of the All-U-Need

machine. It is a 250V, 2AMP slo-blo cartridge fuse.

If you need a replacement, this fuse can be found

at your local hardware store. See below for how

to change the fuse.

Push in with a flat head screwdriver, then turn to the left

(counter-clockwise)