Agriframes 4ft Green Rose Arch Instruções de montagem - Página 3

Procurar online ou descarregar pdf Instruções de montagem para Equipamento para relva e jardim Agriframes 4ft Green Rose Arch. Agriframes 4ft Green Rose Arch 3 páginas.

Imprimir página

3. Site preparation

3.1. Place the roof structure in the site that you intend to install the arch and mark the positions of the four

uprights. Remove the roof section and use the Holemaker provided to make 13" deep holes at the four

marks. Ensure that the holes are all vertical and the same depth.

3.2. Remove the two lower spacers from the roof assembly.

3.3. Place one of the uprights with an end plug in each hole and ensure that the tops are level. Adjust if

necessary.

4. Final assembly

4.1. Refer to the measurements in the diagram. Slide one spacer bar

assembly onto each pair of uprights to connect them together.

Attach the spacers 9" above the ground. Slide a moisture seal

onto the top of each upright.

4.2. Connect a second upright to the top of the four positioned in the

holes and slide a second spacer onto each side. Attach the spacer

40" above the first.

4.3. Slide a third spacer bar onto each side and attach it 7" above the

second spacer.

4.4. Slide a moisture seal onto the top of each upright and lift the roof

section onto the uprights. Once it is attached securely slide the

moisture seals up to cover the tube joins.

4.5. Check that all the measurements are correct and then fully

tighten all the screws.

4.6. If you purchased the lattice infill it can be attached to the

structure, between the horizontal spacers, using the ties provided.