Hi-Z Antennas Hi-Z 8A-80 Manual - Página 9

Procurar online ou descarregar pdf Manual para Antena Hi-Z Antennas Hi-Z 8A-80. Hi-Z Antennas Hi-Z 8A-80 14 páginas. 160/80 meters 200/100 foot diameter circle, a models have the pre-amp external level1 plus amps, level2 with plus6 amps

Imprimir página

The direction-switching table is as follows.

DIRECTION

Ground Ctrl 1

Ground Ctrl 2

Ground Ctrl 3

Ground Ctrl 4

Ground Ctrl 1 & Ctrl 5 S

Ground Ctrl 2 & Ctrl 5 SW

Ground Ctrl 3 & Ctrl 5 W

Ground Ctrl 4 & Ctrl 5 NW

The output impedance of the array is 75 ohms. Although you could likely get away with just connecting it to you

50-ohm receiver under a lot of conditions, it is best if you use a matching 75 to 50 ohm transformer. This allows the

included preamplifier to give maximum IMD performance.

The Coax Power In terminal is provided to disconnect the +13.8VDC sent out to all the controller antenna

inputs for powering the Hi-Z amps at the elements. Removing the factory jumper removes the voltage on

the antenna inputs.

Signal Sources (handy device for testing and troubleshooting)

For BCI:

Hi-Z Band Pass Filter (BPF)

Hi-Z High Pass Filter (HPF)

Troubleshooting:

Please look on our website at

Hi-Z 8A Element Man. 3.0

Hi-Z 75Ω Pre-amp PLUS

Hi-Z 75Ω to 50Ω Transformer

http://www.hizantennas.com/high_pass.htm

http://www.hizantennas.com/band_pass.htm

http://www.hizantennas.com/hiz_faq.htm

http://www.hizantennas.com/signal_source.htm