GREAT PLAINS BD7600 Manual de ajuste de campo - Página 12
Procurar online ou descarregar pdf Manual de ajuste de campo para Perfurar GREAT PLAINS BD7600. GREAT PLAINS BD7600 12 páginas. Box drill
Também para GREAT PLAINS BD7600: Manual de início rápido (20 páginas)
Imprimir página
How To Lower Drill Once Unfolded:
Note: Always unfold the drill before lowering to avoid
tire damage. If a selector valve is installed, make sure
it is set for transport lift.
1) Slowly extend the lift cylinders. Set the tractor
hydraulic lever to neutral. Move the center transport
lift handle up to FIELD position to release the trans-
port lock.
2) Slowly lower the drill. Keep the circuit engaged until
both lift cylinders are completely retracted and wing
tilt cylinders are extended. Set the circuit to neutral.
3) If operating in the field, position all opener lock han-
dles in FIELD position.
4) Completely raise the openers to allow the spring
loaded opener locks to disengage.
Feed Cup Flap Adjustment:
A handle (1) at the rear center of each drill box adjusts
the feed cup flap for seed size or clean-out.
The handle has five positions:
1) Position 1 - small seeds
2) Position 2, 3, and 4 - medium to extra large
3) Position 5 - Clean out
To change positions, pull out the handle and move it
to the appropriate position. Set all boxes the same.
Feed Cup Slide Gate Adjustment:
Each slide gate (4) has three positions:
1) Position A (4) - closed
2) Position B (5) - partially open
3) Position C (6) - fully open
Document
#DRUS400C-0012A
49649
49650
12 of 12