GREAT PLAINS QM150 Manual do Proprietário - Página 3

Procurar online ou descarregar pdf Manual do Proprietário para Instrumentos de medição GREAT PLAINS QM150. GREAT PLAINS QM150 16 páginas. Positive displacement fuel meter

Imprimir página

INSTALLATION

Before installing your meter, review

the safety instructions given above�

Examine your meter to make sure

there are no visible signs of shipment

damage� Plan your meter installation

by reviewing the following procedures�

Your system must be mounted on a

vented tank� If the tank is unvented,

your local dealer or distributor can

supply a pressure cap�

If the meter is located in a rigid piping

system where the fluid is trapped

(for example, by gravity, valves or

nozzles) thermal expansion of the fluid

can create pressure spikes that can

damage a meter� Install a thermal relief

valve or otherwise allow for thermal

expansion of the fluid�

The flowmeter MUST be mounted so

that the rotor shafts are in a horizontal

plane� Mounting the meter with the

mechanical display facing horizontally

will orient the rotor shafts correctly�

The mechanical display should never

face upwards or toward the ground�

The weight of the rotors must be

supported by the horizontal rotor shafts�

If installed incorrectly, performance,

life or accuracy could be affected�

(see Figure 1)

Horizontal Flow

figure 1

Liquid can flow in a horizontal direction,

or a vertical direction, but in each case

the rotor shafts must be in a horizontal

plane�

It is preferred to install the flow-meter

upstream of a flow control or shut-off

valve, as the back pressure provided

by the valve will be beneficial to system

accuracy� The flow meter should

remain full of liquid at all times when

connected�

Do not operate the flow-meter directly

discharging to the atmosphere�

Prior to installation, determine whether

horizontal or vertical flow is required�

For vertical flow installations the liquid

should travel from bottom to top, i�e�

it should rise vertically through the

flow-meter� This will ensure that the

flow-meter remains full of liquid, and

will prevent air entrapment in the meter�

The back of the meter housing is

embossed with "INLET" and "OUTLET"

adjacent to its respective port to assist

in correct piping connections�

Correct

InCorrect

Correct

Vertical Flow