CEL Multi2PRO Manual do utilizador - Página 16
Procurar online ou descarregar pdf Manual do utilizador para Equipamento para relva e jardim CEL Multi2PRO. CEL Multi2PRO 20 páginas. 10.8v li-ion cordless
Imprimir páginaOverload and Low Voltage Protection
9.1
Overload Protection
When the unit is overloaded (e.g.: the product is working too hard or the blade is
jammed) the current will increase rapidly, this triggers the auto cut-off, indicated by
a RED flashing LED. To reset, slide the power switch to the "OFF" position and
restart again after re-adjusting to a proper cutting pressure/angle as well as
choosing a higher torque setting.
Low Voltage Protection
When the discharging current is too high or the remaining battery voltage is not
enough to drive the machine, the power supply stop automatically and the LED
lights will go out. To reset, slide the power switch to "OFF" position and restart.
Note: If this happens frequently the battery capacity is low, please recharge your
battery.
Maintenance
10.0
WARNING, Switch off and remove the battery before carrying out any
maintenance on the tool.
General inspection
Regularly check that all the fixing screws are present and tight. They may
vibrate loose over time.
Dust
Keep the tool' s air vents unclogged and clean at all times.
Remove dust and dirt regularly.
Cleaning is best done with compressed air or a rag.
Never use caustic agents to clean plastic parts.
CAUTION, Do not use cleaning agents to clean the plastic parts of the tool. A
mild detergent on a damp cloth is recommended. Water must never come into
contact with the tool.