ADEMCO LYNXR24 Manual de início rápido - Página 7
Procurar online ou descarregar pdf Manual de início rápido para Sistema de segurança ADEMCO LYNXR24. ADEMCO LYNXR24 8 páginas.
Também para ADEMCO LYNXR24: Manual de início rápido (8 páginas)
Imprimir página
Remote Phone Control Operation
To remotely disarm system:
To remotely arm in AWAY mode:
To remotely arm in STAY mode:
To remotely arm in AWAY or STAY with NO DELAY:
To remotely activate X-10 devices 1-6: [#] + [4] + device no.
To remotely activate X-10 devices 7 & 8:
To remotely deactivate X-10 devices 1-6: [#] + [7] + device no.
To remotely deactivate X-10 devices 7 & 8:
To remotely bypass a zone:
To remotely activate forced bypass:
Note: Force bypass option must be enabled.
To remotely check system status: [*]
To end remote phone session: Hang up or
Speaker Phone Operation (LYNXR-EN Only)
(Note: The ARMED and READY LEDs blink alternately when the Speaker Phone feature is active)
To place a call or answer a call using the speaker phone: [#] + AUX
To Flash (switch between two calls using call waiting): AUX
To hang up and exit speaker phone mode: OFF
To enable/disable (toggle) ringer: [#] + VOLUME + AUX
To return the keypad to telephone mode after disarming the system: [#] + AUX
Note: The Babysitter Code and Installer Code cannot disarm the system unless it was the code used to arm the system. In
addition, if the system is armed by pressing and holding the Quick-Arm buttons, neither the Babysitter Code nor the
Installer Code can disarm the system.
REFER TO THE INSTALLATION AND SETUP GUIDE FOR THE LIMITATIONS OF THIS SYSTEM AND
WARRANTY INFORMATION.
+ [1]
+ [2]
+ [3]
+ [#] + [4] + device no.
+ [#] + [7] + device no.
+ [6] + zone no.
+ [6] + [#]
+ [9]
-7-
+ [2] or [3] + [0]