HiB Proton Instruções de montagem - Página 2

Procurar online ou descarregar pdf Instruções de montagem para Mobiliário de interior HiB Proton. HiB Proton 4 páginas. Cabinets

Imprimir página

Fixing Preparation (Fig A)

Fixing Brackets (Fig B)

Wall Hung Installation

1. Position the cabinet in a suitable location

(according to the zonal diagram (Fig. 1) on

the back page) ensuring that the mains

supply cable is within reach of the cable

connection point of the cabinet. Carefully

mark the desired position of the cabinet

using a soft pencil, ensuring it is level.

2. Remove the cabinet from the wall and

using a spirit level, mark a horizontal line

below the pencil mark, taking into account

the location of the mounting points (Fig.

A). Place brackets on the pencil line paying

attention to the distance netween the

hangers on the cabinet. Carefully mark the

position of the holes using a soft pencil.

(Fig. B).

3. Before drilling, ensure there are no hidden

cables or pipes behind the mounting

points. Using a suitable drill bit, drill holes

in the marked positions to a suitable depth.

4. Insert wall plugs level with the surface

of the wall. If fitting to a tiled surface,

wall plugs should be inserted below the

tile surface to avoid cracking. NB. For

REAR VIEW

Mounting Points

location of internal

ﬁxing hole

Hanger Adjustment (Fig C)

plasterboard walls, specialist fixings should

be purchased from any DIY or hardware store.

5. Fix the brackets to the wall using the screws

provided.

6. Carefully remove the small screws along

the top front edge of the cabinet to gain

access to the internal panel(s). (Fig. C) Keep

screws in a safe place.

7. Temporarily hang the cabinet ensuring the

claws on the hangers are securely located

on the wall brackets. Using a spirit level

adjust the cabinet via the screws on the

hangers. (Fig. C).

8. Mark the position of the internal fixing hole

and remove the cabinet. Using a suitable

drill bit, drill a hole and insert a wall plug as

per stage 4.

9. Connect the cable at the rear of the cabinet

to the mains supply cable using a suitable

terminal block (not supplied) according

to the wiring diagram (Fig. 2) on the back

page.

10. Rehang the cabinet in position, tighten the

screws on the hangers (Fig. C) and secure

Angle Adjustment

Claw In/Out

Adjustment