GREAT PLANES Dazzler ARF Manual de instruções - Página 11

Procurar online ou descarregar pdf Manual de instruções para Brinquedo GREAT PLANES Dazzler ARF. GREAT PLANES Dazzler ARF 20 páginas.

8. Install the servo using the hardware provided from

the radio manufacturer.

9. Repeat steps 6-8 for the left wing.

10. Install three servos into the servo tray using the

hardware provided by the manufacturer. Position the servos

as shown in the photograph.

11. The open area in front of the servo tray is where you

will locate the battery and receiver. Cut a piece of the foam

pad and fit it in the opening. Lay the battery on the foam. Cut

another piece of the foam pad and lay it on top of the battery,

then place the receiver on top of the foam. Optional:

Depending on the size of the battery and receiver you may

choose to put them on end, side by side.

12. Connect all of your servo leads into the receiver as

recommended by the radio manufacturer. The aileron servos

can either be connected by a Y-harness or if you have a

computer radio with channel assignments you can plug

each servo into a separate channel. See your radio

instruction manual for the set-up procedure.

13. Locate the radio compartment cover. Measure

5-1/8" [128mm] from the back edge of the cover towards the

center of the cover and make a mark. Draw a line across the

width of the cover. This is the center line for the switch and

charging jack installation. It is important that this line falls

between the servo tray and the cavity for the battery and

receiver or there may not be enough room for the switch and

charge jack. Before cutting the location for them, visually

check to be sure the line falls in the correct location.

14. Cut the openings and install the switch and charge jack.

15. Locate four 1/4" x 9/16" x 9/16" [6 x 14 x14mm]

hardwood blocks. Glue them in each corner on the inside

of the radio compartment cover.

16. Connect the battery to the switch harness and receiver.