GREAT PLANES Gitabria Manual de instruções - Página 13

Procurar online ou descarregar pdf Manual de instruções para Brinquedo GREAT PLANES Gitabria. GREAT PLANES Gitabria 20 páginas. Electrifly series

❏

6. Insert the z-bend of both aileron pushrods in the aileron

servo extension.

❏

7. Insert an ABS aileron control horn onto the end of both

aileron pushrods. Insert the aileron control horns in the slot in

both ailerons. With the transmitter switched on and the aileron

servo arm centered, check that both ailerons are centered.

If they are not, adjust the length of the aileron pushrods as

needed. Then, glue the aileron control horns in the aileron.

Again, check that the ailerons are centered and apply a drop

of thin CA to the end of the heat shrink tubing.

INSTALL THE MOTOR

❏

1. Install the motor to the motor mount using the included

#2 x 3/8" [9.5mm] self-tapping screws.

❏

2. Insert the landing gear through the landing gear support

and into the horizontal fuselage. Be careful not to push the

landing gear all the way through the horizontal fuselage. The

end should be ﬂ ush with the top of the horizontal fuselage.

If it is difﬁ cult to insert both landing gear legs through the

landing gear support, use a hobby knife to enlarge the hole

slightly. Rotate the wheels so that they are parallel to each

other. Apply foam-safe CA to the joint between the landing

gear support and the landing gear legs and the horizontal

fuselage and the landing gear legs.

❏

3. Place a small piece of loop (soft) side of the self adhesive

hook and loop material to the back of the ESC and the receiver.

❏

4. Place a piece of hook (rough) material under the

fuselage, close to the front. Route the motor leads through

the fuselage and connect them to the motor. Attach the ESC

to the hook material.