GREAT PLANES Mini Slinger Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Brinquedo GREAT PLANES Mini Slinger. GREAT PLANES Mini Slinger 12 páginas.

❏

4. Locate the four 2-1/2" [64mm] pushrods and two 1"

[25mm] long pieces of heat shrink tubing. Using the 90°

pushrod connectors, attach a pushrod to the outer hole of

each servo horn and the middle hole of each control horn. If

necessary, use a 1/16" [1.6mm] drill bit to enlarge the holes.

Insert a piece of heat shrink tubing onto the two pushrods

attached to the servo horns.

❏

5. Use tape to temporarily hold the elevons in the neutral

position. Overlap the pushrod ends and join them together

using the heat shrink tubing. Use a soldering iron to shrink

the tubing around the pushrods by moving it quickly back

and forth across it (do not use a micro torch or heat gun to

shrink the tubing as this will melt the foam close to the

pushrods). With the elevons still in the neutral position, apply

a couple drops of CA glue to each end of the heat shrink

tubing to secure them in place.

Install the Radio Equipment

❏

1. Using rubbing alcohol, clean the area where the radio

tray will be installed. Feed the servo wires through the hole

in the hatch. Peel the paper backing from the tape on the

underside of the radio tray hatch and press it into position. Be

sure that the hatch is held securely in place by the tape.

❏

2. Install the sling handle on the underside of the wing

in the same manner.

❏

3. Drill a 1.6 mm [1/16"] hole at an angle through the

corner of the radio tray and out the bottom of the wing.