GREAT PLANES Riot 3D Manual de instruções - Página 10

Procurar online ou descarregar pdf Manual de instruções para Brinquedo GREAT PLANES Riot 3D. GREAT PLANES Riot 3D 20 páginas.

❏ ❏

9. Drill a 3/32" [2.4mm] hole and glue the pushrod

standoff (E3) in place as shown.

❏ ❏

10. Align the rudder at neutral with the servo arm

centered. Apply a small drop of thin CA where the pushrod

enters each clevis.

❏ ❏

11. Repeat steps 1-10 for the elevator pushrod. Final

installation should resemble the photo above.

❏

12. Glue a servo in place in the bottom wing as shown.

❏

13. Install two Z-bend clevises (A1) into the outer holes on

the double servo arm (G4).

❏

14. Attach a double servo arm (G4) that fits your servo.

Enlarge the outer holes in the double servo arm (G4) before

installing the arm on the servo.

❏

15. Install Z-bend clevises (A1) into two control horns

(B1) and glue them in place as shown. Press a backplate

(B2) onto the back side of the control horn (B1). The Z-bend

clevises (A1) should be installed on the outer side of the

control horn (B1).

❏

16. Locate the two 6" [153mm] carbon pushrods. Insert

the pushrod into the Z-bend clevises (A1) as shown. Using

your radio, center the servos and align the ailerons at

neutral. Adjust the pushrods as needed. Secure in place with

a drop of thin CA where the pushrods enter the Z-bend

clevises (A1).