GREAT PLANES SU-31 Manual de instruções - Página 8

Procurar online ou descarregar pdf Manual de instruções para Brinquedo GREAT PLANES SU-31. GREAT PLANES SU-31 16 páginas. Park flyers series

hardwood strip at the front of the fuselage. The motor shown

is a MEGA Can 16/15/3 brushless. Note: The tie-wraps may

not hold the motor tightly enough to prevent it from twisting

slightly at full power with the prop installed. If this happens,

put a small drop of CA on the rear of the motor where it

touches the fuselage.

2. Trim the foam fuselage as needed for wires from the motor

Install the ESC

1. The Electronic Speed Control (ESC) can be held to the

fuselage with a short piece of the included hook and loop

tape. The speed control shown is a Kontronik Smile 30-6-12.

2. Mount the ESC switch to the side of the fuselage with

6-minute epoxy. Do not use CA as it could get into the switch.

3. Route the receiver connector wire from the ESC into the

battery compartment and then to the extension wire from the

receiver. Fasten the wire to the top of the battery compartment

with some tape.

Install the Tail Surfaces

1. On a flat surface, glue the 1/8" x 3/16" x 11-7/8" [3.2 x

4.8 x 302mm] hardwood elevator joiner in place with

6-minute epoxy. Make sure the elevators are aligned with

each other. Note: Use some plan protector or wax paper on

your building surface.

2. Using a fine tip marking pen, measure and mark the

centerline on the top of the horizontal stab. At the leading

edge, put a mark 5/16" [8mm] on each side of the centerline.

Note: The top of the horizontal stab has the clear cellophane

tape hinge applied to it.