Automate AM2 Manual de instalação - Página 10

Procurar online ou descarregar pdf Manual de instalação para Alarme para automóvel Automate AM2. Automate AM2 18 páginas.
Também para Automate AM2: Manual do Proprietário (19 páginas)

Imprimir página

For example, to program the arming mode from active to passive, within 10 seconds of turning the

ignition off, and press and release the Valet/Program switch once. Then press it again and hold it.

The LED will flash in groups of one and the horn will honk once (if connected). While holding the

Valet

/Program switch, press the unlock button. The LED will continue to flash twice. The horn

will honk twice if connected. Passive arming is now programmed. If that was not the desired setting,

without releasing the Valet

the horn will honk once if connected. Active arming is now programmed. Release the

Valet

/Program switch after the selection has been made.

You can advance from feature to feature by pressing and releasing the Valet

number of times necessary to get from the feature you just programmed to the feature you wish to

access. For example, if you just programmed Feature 2 and you next want to program Feature 3 to

off, release the Valet

/Program switch. Press and release it once to advance from Feature 2 to Feature

3. Then press it once more and hold it. The LED will flash in groups of three and the horn will

honk three times (if connected) to confirm that you have accessed Feature 3.

The learn routine will be exited if:

➤

The ignition is turned on.

➤

The Valet/Program switch is pressed too many times.

➤

More than 15 seconds elapses between programming steps.

One long horn honk (if connected) indicates that the Learn Routine has been exited.

T T r r a a n n s s m m i i t t . . The transmitter is used to select the desired setting. As shipped,

the unit is configured to the LED ON/1 chirp settings. These are the

default settings. Pressing the lock button will move settings back to the

LED ON/1 chirp setting. The LED will light solid (stop flashing) to

indicate the setting. The horn will honk once (if connected). Pressing the

unlock button will change the setting to the LED OFF setting. The LED

will go out indicating the change and the horn will honk twice (if

connected). Features with more than two setting options, please see note

below.

Release. The Valet

/Program switch can now be released.

/Program switch, press the lock button. The LED will light solid and

/Program switch the

2007

Directed Electronics