GREAT PLANES ZERO Manual de instruções - Página 6

Procurar online ou descarregar pdf Manual de instruções para Brinquedo GREAT PLANES ZERO. GREAT PLANES ZERO 16 páginas. Electrifly series

ASSEMBLE THE AIRPLANE

❏

1. Connect the aileron servo to the receiver. Use your

ESC or a receiver pack to power the receiver. Turn on your

transmitter and center the aileron servo. Do not skip this

step, as the aileron servo must be installed into the fuselage

with the servo horn attached to it.

❏

2. Cut two arms from a four-arm servo horn as shown.

Enlarge the outer holes in the remaining servo arms with a

3/64" [1.2mm] drill bit.

❏

3. Install the servo horn perpendicular to the servo case.

❏

4. Feed the aileron servo wire out of the right side of the

aileron servo bay. Fit the aileron servo into the aileron servo

bay with the servo spline towards the rear of the plane. Apply a

couple of drops of thick foam safe CA glue to each servo case

tab, securing the servo to the fuse. Add a couple of drops of CA

glue near the base of the servo case as well. It does not require

much CA glue to secure the servo to the fuse. Excess glue will

simply make it difficult to remove the servo in the future.

❏ ❏

1. For the best adhesion on the painted surfaces,we

recommend roughing up the painted surfaces to be glued

with fine grit sandpaper such as 320-grit. Wiping the areas

to be glued with a paper towel dampened with denatured

alcohol will reduce the gloss of the paint and also improve

adhesion. If using alcohol, we recommend only making one

pass with the towel. Excessive wiping will completely

remove the paint from the foam.

❏ ❏

2. Apply a bead of thick CA glue to the tops of the wing

supports on the left side of the fuse. We recommend using

CA accelerator to speed assembly time.