DayStar Filters SOLAR SCOUT Manual - Página 13

Procurar online ou descarregar pdf Manual para Telescópio DayStar Filters SOLAR SCOUT. DayStar Filters SOLAR SCOUT 17 páginas. 60mm dedicated solar telescope

Imprimir página

Troubleshooting:

Blank, featureless disk:

Ensure power is applied and LED is green.

Try moving focus in and out 3-4 complete revolutions of the grip.

Make sure a 25 to 40mm eyepiece (not included) is installed.

Ensure knob is pointing straight away from the power jack.

Check for droop, all connections must be tight and square.

Poor contrast:

Check that optical surfaces are clean. Dust specks do not affect

the view, check for smudges such as oil from fingerprints.

Try adjusting wing shift knob up 3-4 clicks clockwise past center

and wait 5-10 minutes. If that does not improve the view, try down 3-4

clicks below center and wait 5-10 minutes.

Atmospheric seeing or transparency may be poor, try again later.

Blurry image:

Blurry views are typically due to poor seeing. Poor seeing can

be caused by the presence of heat waves from concrete, asphalt, or

machinery. Weather effects like the jet stream can also cause blurring.

Try moving to a different location or else observe on a day when weather

conditions are improved.

Yellow LED indication:

Your filter is adjusting to the wavelength chosen by the knob.

Wait approximately 5-10 minutes for the temperature to adjust and then

light should turn green, indicating that the filter has settled to its required

temperature and is on band for viewing.

Yellow, never goes green LED indication:

If after 20 minutes of the same knob position setting the LED has

not turned green, the ambient temperature may be too hot or too cold for

the Scout to regulate the temperature. However, the filter may still be

usable while slightly mistuned and performance may not be affected.

This can also occur if plugged into a power supply with

insufficient current or voltage. Please use the provided AC adapter.

Red LED indication:

This usually indicates that the telescope is not receiving enough

voltage. If powered by battery, recharge the battery. Make sure to use

the supplied AC/DC wall adapter, as cell phone chargers and PC USB

ports do not have enough current capability for the telescope.

Red indication can also mean an electrical fault in the telescope

electronics. If power source changes do not resolve the red indication,

please return the telescope to DayStar for inspection and repair.