DAYTAI DT-OLS-116 Manual do utilizador - Página 14

Procurar online ou descarregar pdf Manual do utilizador para Equipamento de iluminação DAYTAI DT-OLS-116. DAYTAI DT-OLS-116 16 páginas. Optical light source

Imprimir página

5.5 Wavelength Automatic Identification



Connect

The light source with its same serials power meter THE MATCHED OPTICAL POWER

METER.

Enable light source be Under "Wave ID" operation mode: press



its matched power meter, Hold down

also "--AU" will be shown on the upper right of LCD for a indication.



Enable power meter be under "Wave ID"operation mode: Hold down

will be enter into Wave ID mode, also "--AU"will be shown on the upper right of LCD for a indication.



Once the ID information is changed from light source(press

seconds later, the detected information on optical power meter also will be changed automatically

according to light source. Please refer to below figure(5-14) for easy understanding.

Exit Wave ID mode: Hold down



again to exit Wave ID mode from light source.

1310nm(xxdBm)

1550nm(xxdBm)

......

5.6 Frequency detection



Connect The light source with its same serials/matched power meter



Output frequency from the optical light source: Press

press

2KHz accordingly， which will be shown on the upper right of the LCD in The light source. In the mean

time, the THE MATCHED OPTICAL POWER METER will detect the corresponding frequency

automatically from The light source. Please refer to below figure (5-15) for better understanding:

again to exit Wave ID mode from power meter and hold down

Light source

for very short second， The light source will output frequencies of 270Hz、 330Hz、 1KHz、

Optical Light Source (DT-OLS-116)

for few seconds，light source will be enter into Wave ID mode,

THE MATCHED POWER METER

5-14

of light source to laser on

for few seconds，power meter

to change wavelength), after 3 to 5

1310nm(xxdBm)

1550nm(xxdBm)

......

to emerge light from the unit,