Automatic CS184-A Manual de instruções - Página 12

Procurar online ou descarregar pdf Manual de instruções para Serra Automatic CS184-A. Automatic CS184-A 16 páginas. 1500w 184mm (7 1/4”)

Changing the blade

CAUTION. Always ensure that the saw is switched off

and unplugged from the power supply before making any

adjustments.

1. Place saw on its side on a flat surface.

2. Rotate the saw blade by hand whilst depressing the

spindle lock button until the blade locks (Fig. Q).

3. Whilst depressing the spindle lock button, turn the blade

bolt anti-clockwise using the Blade Wrench provided

(Fig. R).

4. Remove the outer blade

flange and the blade bolt.

5. Raise the lower blade guard

using the blade guard lever.

6. Remove the saw blade from

the inner flange and pull it

out (Fig. S)

7. Clean the saw blade flanges

thoroughly before mounting

the new saw blade. Wipe a drop of oil onto the inner and

outer flange where they will touch the blade.

8. Mount the new saw blade

onto the spindle and against

the inner flange. Check the

direction of rotation of the

blade matches the direction

arrow on the saw guard.

Check the speed rating of

the blade exceeds the No

load speed rating on the saw.

Blade must be 5500 minimum rating for this saw.

9. Replace the outer flange and tighten the blade bolt

(Fig. T).

WARNING. The direction in which the blade rotates has

to be the same as the direction of the arrow marked on

the housing.

10. Ensure that the spindle lock button is released.

11. Before using the saw again, check that the safety

devices are in good working order.

IMPORTANT. After replacing the saw blade, make sure that

the saw blade runs freely by turning the blade by hand.

12. Plug the machine into a power socket and run the saw

under no load to check that it runs smoothly before

using it to cut any material.