Automatic SA200-A Manual de instruções - Página 8

Procurar online ou descarregar pdf Manual de instruções para Lixadeira Automatic SA200-A. Automatic SA200-A 11 páginas. 200w 1/3 sheet sander

Imprimir página

Assembly

WARNING: Always ensure that the tool is switched
off and the plug is removed from the power point before
making any adjustments or maintenance procedures.
1. Installing and replacing the sanding sheet
Sanding Sheets with Hook and Loop Backing
(a) The sanding plate is fitted with hook and loop backing
for quick and easy fastening of sanding sheets with
hook and loop adhesion. Before attaching the sanding
sheet, free the hook and loop backing of the sanding
plate from any debris by tapping against it in order to
enable optimum adhesion. Position the sanding sheet
flush alongside one edge of the sanding plate, then lay
the sanding sheet onto the sanding plate and press
firmly.
(b) To remove the sanding sheet, grasp it at one of the tips
and pull it off from the sanding plate.
2. Sanding Sheets without Hook and Loop Backing
(a) Lightly lift and unlatch the sanding-sheet clamp
lever(7). Position the sanding sheet under the opened
rear sanding sheet clamp(4) to the stop and clamp the
sanding sheet by reinserting the sanding-sheet clamp
lever(7).
(b) Fold the sanding sheet firmly around the sanding
plate. Guide the other end of the sanding sheet under
the front sanding-sheet clamp lever(7) and clamp the
sanding sheet by reinserting the sanding-sheet clamp.
(c) To remove the sanding sheet, unlatch the sanding-
sheet clamp lever(7) and pull out the sanding sheet.
3. Installing the dust bag
Attach the dust bag onto the dust port. There are 2
raised bar-type blocks on the outside of the dust port.
The dust bag has the same shape to enable connection
to the port. When attaching the dust bag, push it onto
the dust port firmly as far as it will go to prevent it from
coming off during operation.
For the best results, empty the dust bag when it
becomes approximately half full, tapping it lightly to
remove as much dust as possible.
Notes: Prevent dust accumulation at the workplace.
Dusts can easily ignite.

Operation

WARNING: Observe correct mains voltage! The voltage
of the power source must agree with the voltage specified
on the nameplate of the machine.
Switching On and Off
CAUTION: Make sure the tool is not resting on any
surface when it is switched on.
To start the machine, push the On/Off siwtch marked
"I" on the left hand side of the sander.
To switch off the machine, push the On/Off switch
marked "O" on the right hand side of the sander.
CAUTION:
• Never run the tool without the abrasive paper. You may
seriously damage the pad.
8