Daytona DS300LRBL Manual do proprietário e instruções de segurança - Página 7
Procurar online ou descarregar pdf Manual do proprietário e instruções de segurança para Valetes Daytona DS300LRBL. Daytona DS300LRBL 13 páginas.
Imprimir página
Operation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Lifting
Park vehicle on a flat, level, solid, surface safely away from oncoming traffic. Turn off the vehicle's engine.
Place the vehicle's transmission in "PARK" (if automatic) or in its lowest gear (if manual).
Set the vehicle's emergency brake. Then, chock the wheels that are not being lifted.
1. Turn the Handle counterclockwise to lower the Jack.
Once the Jack is fully lowered, turn the
Handle firmly clockwise to close it.
2. Carefully position the Saddle of the Jack under the
vehicle manufacturer's recommended lifting point.
(See vehicle manufacturer's owner's manual
for location of frame lifting point.)
3. Step on Foot Pedal until the top of the Jack's Saddle
has nearly reached the vehicle lifting point. Position
the Saddle directly under the vehicle's lifting point.
4. To lift the vehicle, pump the Handle.
Use smooth, full strokes.
5. Once the vehicle is raised, slide a jack stand of
appropriate capacity (not included) under a proper
lifting point referred to in the vehicle owner's
manual. Always use two jack stands, position them
at the same point on each side of the vehicle.
Lowering
1. Carefully remove all tools, parts, etc.
from under the vehicle.
2. Position the Saddle under the lifting point.
Turn the Handle firmly clockwise and raise
load high enough to clear the jack stands,
then carefully remove jack stands.
Item 56641
For technical questions, please call 1-888-866-5797.
WARNING! The rated capacity of jack stands is per
pair, not the individual capacities combined unless
specifically noted on the product by the jack stand
manufacturer. Do not exceed rated jack stand capacity.
Ensure that the vehicle support points are fully seated
in the saddle of both jack stands. Use a matched pair
of jack stands per vehicle to support one end only.
Failure to do so may result in the load suddenly falling,
which may cause personal injury and/or property damage.
6. Center saddle of the jack stand(s) under the vehicle's
lifting point(s). Set the jack stand(s) to the same
height according to the manufacturer's instructions,
making sure that they lock securely into position.
7. Slowly turn the Handle counterclockwise to lower
the vehicle onto the saddle(s) of the jack stand(s).
Then, turn the Handle firmly clockwise to close it.
3. Slowly turn the Handle counterclockwise
(never more than 1/2 full turn) to lower
the vehicle onto the ground.
4. Lower the Jack completely. Then, store in a
safe, dry location out of reach of children.
Page 7