DaytonAudio APA150 Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Amplificador DaytonAudio APA150. DaytonAudio APA150 4 páginas.
Imprimir página
Power Output:
Total Harmonic Distortion:
Signal-to-Noise Ratio:
Crossover:
Auto-On Sensitivity:
Auto-Off Delay Time:
Input Impedance:
Line-Out Frequency Response:
Maximum Noise and Hum:
Minimum Clearance for Ventilation:
Electrical Requirement:
Stand-by Power Rating:
Dimensions:
Weight:
To reduce the risk of electric shock, do not remove cover. No user serviceable parts inside. Refer servicing to qualifi ed personnel.
To reduce the risk of fi re and shock do not expose unit to rain or moisture. The unit should be connected to an earth grounded AC
electrical socket. The unit should be operated in a well ventilated area. Minimum clearance is 2 inches from the ventilation openings.
Note: Unit is set at the factory for 120V operation. Be sure to change the fuse (1.6A rating) before switching to 230V operation.
Dayton Audio products are constructed by industry experts and thoroughly tested before shipment. Dayton Audio products are warranted for the period
of one year. This warranty is limited to manufacturer defects, either in materials or workmanship. Dayton Audio is not responsible for any consequential or
inconsequential damage to any other unit or component, or the cost for installation or extraction of any component of the audio system. In the rare case
of a product failure, please contact your place of purchase or call our Customer Support Department at (937) 743-8248.
There are no other warranties, either expressed or implied, that extend the foregoing, and there are no warranties of merchantability or fi tness for any
particular purpose. The warranty will not cover incidental or consequential damage due to defective or improper use of products. This includes but is not
limited to burnt voice coils, overheating, bent frames, holes in the cone, or broken lead wires.
This warranty gives you specifi c legal rights and you may also have other rights that vary from state to state.
Non-Warranty Service: If non-warranty service is required, the product may be sent to the Company for repair/replacement, transportation prepaid, by
calling (937) 743-8248 for details, complete instructions, and service fee charges.
Dayton Audio
®
SPECIFICATIONS:
75 watts RMS x 2 into 4 Ω, 150 watts RMS x 1 into 8 Ω
Less than 0.01% (20-20,000 Hz)
>100 dB, unweighted
Variable 50-150 Hz, 18 dB/octave
3 mV
15 minutes
47 k Ω ±5%
20-20,000 Hz (-3 dB)
Less than 1 mV with gain at maximum and input shorted
2"
120V 60 Hz, 230V 50 Hz (switchable)
120V 6W; 230V 7W
5.6" H x 5.7" W x 12.8" D
11.05 lbs.
IMPORTANT SAFETY INSTRUCTIONS
Warranty Information
Warranty Limitations
daytonaudio.com
tel + 937.743.8248
(4)
705 Pleasant Valley Dr.
Springboro, OH 45066
USA
Last Revised: 3/13/2015