GAI-Tronics 1090 Manual de instalação e do utilizador - Página 12
Procurar online ou descarregar pdf Manual de instalação e do utilizador para Telefone GAI-Tronics 1090. GAI-Tronics 1090 20 páginas. Hands-free telephones vandal resistant (vr) and help point
Imprimir página
7.
Programming and Option Settings
Programming and option setting is done remotely by sending commands
down the telephone line to the unit. This can be done by either using a tone
phone, or by using GAI-Tronics TMA - a PC software application.
7.1. Quick Programming Guide (using a tone phone).
Autodial memory numbers can be programmed remotely using a tone dialling
(DTMF) telephone. The procedure is as follows:
1)
Lift the handset of the tone dialling telephone.
2)
Dial the number of the telephone to be programmed.
3)
Listen for the ringing tone in the handset earpiece.
4)
After 4-5 rings a beep will be heard, immediately after the beep press
the star key three times. Note the number of rings before the beep is
heard is user configurable, this may be set between 0 and 15 rings
before the beep is sent.
5)
The SMART telephone should now stop ringing. Pause for 3 seconds.
6)
Enter the factory preset PIN Number (**0000). Pause for 3 seconds.
7)
To program Memory 1, Press *101 followed by your required number for
the first Memory Button then hash (#) to complete. The smart phone
should confirm acceptance with a 'beep'.
8)
For Memory 2 follow the same procedure, but this time begin with *102,
followed by your required number for the second Memory Button then
hash (#) to complete. Wait for the confirmation tone.
9)
Continue this procedure for all remaining Memory buttons, as required.
10) When programming is complete, Press *99 to activate remote 'Hang-up'
function.
Example:
Programming requirement
Program Memory 2 with
Trouble Shooting
The SMART Telephone should only return a 'beep' after a Programming
command has been sent. If the SMART phone 'beeps' during Command
entry, then you should try the following:
1)
Problems may occur when the SMART phone is unable to distinguish
between the different command strings and that's why it's important to
pause after the initial entry of the '***' command. Also make sure that
you are leaving a three-second gap after entering the default PIN code.
If this is not the case, then you should begin the above programming
procedure again. (Starting at 5)
12
01234 567890
Command Digits
*102 01234567890#
VR & Help Point