GAI-Tronics KETS 1141 Manual de instalação e do utilizador - Página 11

Procurar online ou descarregar pdf Manual de instalação e do utilizador para Telefone GAI-Tronics KETS 1141. GAI-Tronics KETS 1141 20 páginas. Titan illuminated crossing telephone

Imprimir página

Kit No 100-02-0208-001

This accessory is for mounting GAI-Tronics telephones on to the side of

round poles of 100mm to 200mm diameter, or on to square or

rectangular section uprights of 100mm to 150mm across the mounting

surface.

NOTE:

Banding straps (large scale worm-drive clamps) are not included in this

kit and must be obtained separately. For details of where banding can

be obtained, refer to GAI-Tronics.

1. Using a suitable tool, punch out the 4 outer holes in the rear

enclosure, taking care not to damage or dislodge the plastic

bushes.

2. Attach the pole mounting clamp assemblies to the rear enclosure

using the M6 x 25 screws provided, pushing the screws through

from inside the phone.

3. Tighten nuts to a torque of 4.5Nm max.

IMPORTANT: avoid the use of power tools. Spinning the nuts too

quickly can cause a rapid increase in heat which can cause the nuts

to seize as a result of galling or cold-welding.

Note: only use the outer four holes, and ensure that the screws seat

properly in the plastic bushes to avoid water ingress.

4. Ensuring that the glands are at the bottom, pass a proprietary

banding strap round each of the pole mounting clamps and the

support pole. Tighten securely.

5. Continue the installation by making the appropriate connections

(section 7) and re-fitting the face plate.

6. Re-tighten the straps firmly and trim off any excess band material.

For security the driving head of the band may also be sawn off.

KETS 1141 Titan Illuminated Crossing Telephone