Greatneck 80154 Manual do Proprietário - Página 9

Procurar online ou descarregar pdf Manual do Proprietário para Perfurar Greatneck 80154. Greatneck 80154 16 páginas. 3/8" drill

Imprimir página

ACCESSORIES &

CARTON CONTENTS

AVAILABLE ACCESSORIES

WARNING:

recommended for this drill. Follow

instructions that accompany

accessories. Use of improper

accessories may cause injury to the

operator or damage to the drill.

Do not use any accessory unless you have

completely read the instructions or Owner's

Manual for that accessory.

Drill bits

Screwdriver bits

CARTON CONTENTS

WARNING:

or damaged, do not plug the drill into

the power source until the missing or

damaged part is replaced.

Carefully unpack the drill. Compare

contents against the "Drill Components"

chart below.

WARNING:

reaction, never use gasoline, naphtha,

acetone, lacquer thinner or similar

highly volatile solvents to clean the tool.

DRILL COMPONENTS

DESCRIPTION

Drill

Owner's manual

Use only accessories

If any part is missing

To avoid fire or toxic

QTY

ASSEMBLY & OPERATION

FORWARD/REVERSE LEVER

The forward/reverse lever (1) is

conveniently mounted above the trigger

lever (2) (see Fig. 1). To make the drill

rotate clockwise (for drilling) push the

forward/reverse lever to the left. To make

the drill rotate counter-clockwise for

removing screws, push the forward/reverse

lever to the right.

NOTE: Never change position of the

forward/reverse lever while chuck is

turning.

TRIGGER SWITCH

This drill is equipped with a ON/OFF trigger

switch.

To start drill, gently squeeze the trigger

switch (1) (see Fig. 2).

To stop the drill, release the trigger

switch.

NOTE: Drilling for an extended period of

time may cause the drill motor to overheat.

If the drill motor gets hot, stop drilling and

allow to cool for at least 15 minutes.

Fig. 1