Greatneck 80160 Manual do Proprietário - Página 10

Procurar online ou descarregar pdf Manual do Proprietário para Ferramenta eléctrica Greatneck 80160. Greatneck 80160 20 páginas. Variable speed jigsaw

Imprimir página

Make sure your extension cord is the

proper size. Use the proper minimum

gauge extension cord. An undersized cord

will cause a drop in line voltage resulting in

loss of power and overheating. The table at

right shows the correct size to use

according to cord length and nameplate

ampere rating. If in doubt, use the next

heavier gauge. The smaller the gauge

number the heavier the cord.

Be sure your extension cord is properly

wired and in good condition. Always

replace a damaged extension cord or have

it repaired by a qualified electrician before

using it. Protect your extension cord from

sharp objects, excessive heat and damp or

wet areas.

Use a separate electrical circuit for your

power tools. This circuit must not be less

than 14 gauge wire and should be

protected with either a 15A time delay fuse

or circuit breaker. Before connecting the

power tool to the power source, make sure

the switch is in the OFF position and the

power source is the same as indicated on

the nameplate. Running at lower voltage

will damage the motor.

WARNING:

damaged or worn extension cords

immediately.

Select the appropriate extension cord

gauge and length using the chart on the

following page.

EXTENSION CORD SAFETY

Repair or replace

SAVE THESE INSTRUCTIONS FOR REFERENCE

MINIMUM GAUGE (AWG)

EXTENSION CORDS (120 V use only)

Amperage

rating

Not

25'

than

(7.5 m)

Total length

50'

100'

(15 m)

(30 m)

Not Applicable

150'

(45 m)