GAI-Tronics Page/Party 670-301 Manual de início rápido - Página 9

Procurar online ou descarregar pdf Manual de início rápido para Amplificador GAI-Tronics Page/Party 670-301. GAI-Tronics Page/Party 670-301 10 páginas. Speaker amplifier for cenelec zone 1 applications

Imprimir página

670-301 P

MODEL

AGE

ARTY

Maintenance

In order to verify and ensure explosion-proof integrity, perform regular inspection checks on the GAI-

Tronics explosion-proof enclosure. The GAI-Tronics Field Service Department can formulate a service

contract to suit specific preventive maintenance needs.

Remove power from the enclosure before performing any maintenance.

Use the following procedures to ensure reliable operation of your equipment:

1. Remove power from the enclosure.

2. Unbolt the cover, and remove the amplifier from the enclosure.

3. Visually check the interior of the enclosure for signs of contamination. Contamination inside the

enclosure could mean that the conduit seals or cable gland seals have been compromised.

4. Ensure the gasket and hardware are in place and in good condition.

Note: In certain circumstances, it may be necessary to re-terminate wire connections to some or all

of the enclosures in a system. When this is done, strip the wires back to clean copper, reconnect to

each terminal.

5. Reinstall the amplifier into the enclosure.

6. Re-bolt the cover using the appropriate torque specification. Refer to the Mounting section.

7. Restore power to the unit.

TROUBLESHOOTING

The table below describes possible solutions for some common problems.

Problem

Speaker level requires

adjustment.

Distortion (a hum or buzz on the

line) occurs during all

Page/Party™ station operation.

SPECIFICATIONS

Speaker Amplifier

Power Input ...............................................................90/140 V ac range (120 V ac nominal), 50/60 Hz

Power consumed .......................................................................................... Zero signal: 10 VA, 4.5 W

8/98

k:\standard ioms - current release\instr. manuals (42004)\42004-305.doc

™ S

PEAKER

MPLIFIER

Adjust the speaker volume control at the amplifier.

The line may be improperly terminated. Inspect the system cable for

loose connections, shorts, and grounds. Line balance assembly

connections are critical.

PAGE: 9 OF 10

PUB.: 42004-305

Solution

Max. signal: 50 VA, 27 W

Level 2

Rev: 0