Greatneck 26006 Manual do Proprietário - Página 12
Procurar online ou descarregar pdf Manual do Proprietário para Chave de fendas eléctrica Greatneck 26006. Greatneck 26006 15 páginas.
Imprimir páginaLITHIUM ION BATTERY PERFORMANCE
Lithium ion rechargeable batteries
generally provide superior performance to
nickel-cadmium batteries when used in
power tools.
_
Faster charges
_
Longer battery life
_
More power
_
Lighter weight
Lithium ion batteries perform best and
deliver peak output power at room
temperature (68º F). When operated in
lower temperatures, the battery output will
be reduced and it will NOT function below
0º F. The output power will increase as the
heat generated by the battery during use
increases the internal temperature of the
battery. The result is increased power as
the tool is used.
!
WARNING:
"POWER TOOL SAFETY",
"SPECIFIC SAFETY RULES",
EXTENSION CORD SAFETY" and
"SYMBOLS" on pages 3 through 7 of
this Manual? If not, please do it now
before you operate this cordless
screwdriver. Your safety depends on
it!
Every time you use the cordless
screwdriver you should verify the
following:
1.
Screwdriver bit is the correct
type & size, not worn and not
damaged in any way.
2.
Work piece is properly secured.
3.
Safety glasses are being worn.
Failure to adhere to these safety
rules can greatly increase the
chances of injury or property
damage.
ASSEMBLY & OPERATION
Have you read
DRIVING SCREWS
When driving screws, care must be taken
to use the bit that correctly fits the head of
the screw being driven. Make sure you use
the largest bit size that will properly fit into
the head of the screw. The bits must also
be in good condition and not worn so they
will drive screws without slipping out of the
screw head.
1.
Select the correct screwdriver bit for
the screw being driven.
2.
Insert the magnetic bit holder (1) into
the collet (2) (Fig. 9).
3.
Insert the bit (3) fully into the bit holder.
4.
Insert the screwdriver bit fully into the
screw head (4).
5.
While holding the screwdriver firmly
against the screw and the bit aligned
with the screw, press the upper part of
the switch to start the screwdriver and
drive the screw.
6.
When the screw is driven to the correct
depth, release the switch and the
screwdriver will stop.
7.
When the switch is released and the
screwdriver stops turning, the spindle
will automatically lock. Fully tighten the
screw by manually rotating the
screwdriver handle in a clockwise
direction.
8.
To remove screws, follow the same
general procedure as for driving
screws. When starting the screwdriver,
press on the lower part of the switch.
12