AirCycler g2-k Manual de teste de instalação - Página 2

Procurar online ou descarregar pdf Manual de teste de instalação para Ventilador AirCycler g2-k. AirCycler g2-k 2 páginas.
Também para AirCycler g2-k: Manual de instalação e do utilizador (11 páginas), Manual de formação (20 páginas), Manual de teste de instalação (2 páginas)

HINTS & TIPS

• Make sure the FanConnect switch is in the OFF position when the AirCycler® g2 controller is first

powered on.

• Setup is easier to start without the battery installed. The battery is only used for the real time clock.

If you are not using the operating hours options, the battery is not needed.

TROUBLESHOOTING

No power?

Check common wire connection. "C" must be connected to "C" on the furnace.

EXH icon is flashing

If the EXH icon is flashing it is indicating that the FanConnect switch has been on for more than four

hours or has lost connection with the g2 controller.

My furnace fan runs constantly

Make sure the thermostat FAN switch is set to AUTO and not ON.

Fan does not shut off when AirCycler

is on) Check wiring - G wire from thermostat should be wired to Gt on AirCycler. Gf on AirCycler should

be connected to G on furnace.

FAQ

Will the AirCycler controller lose the settings if the power fails?

No, all settings are saved in non-volatile memory. No battery is needed.

The AirCycler® g2 has a small lithium battery to keep the clock running if you are not ventilating 24hrs

a day and are using that feature. It will maintain the time without power for at least 14 days.

Can I run multiple FanConnect switches off of one AirCycler® g2 controller?

No. For additional bathrooms use the SmartExhaust bath fan/light switch as an independent controller.

g2 is removed from its base (when thermostat fan switch

For more information about this product,

please visit www.aircycler.com or email