Celestron 21049 Configuração rápida - Página 2

Procurar online ou descarregar pdf Configuração rápida para Telescópio Celestron 21049. Celestron 21049 2 páginas. Powerseeker series
Também para Celestron 21049: Manual de instruções (16 páginas), Especificações (2 páginas), Manual de configuração rápida (2 páginas), Manual de configuração rápida (20 páginas), Manual de configuração rápida (2 páginas)

Quick Set-up Guide [cont]

Locate the counterweight bar and

counterweight. Slide the counterweight half

way down the counterweight bar and tighten

the locking screw to secure in place.

The longer cable should attach to the Right

Ascension axis and the shorter cable attaches

to the Declination axis as shown above.

Reattach both wingnuts and tighten to secure

in place.

Insert the chrome barrel of the 20mm eyepiece

into the focuser and tighten the set screw.

Remove the lens cap from the front of the

telescope. To observe, look through the

eyepiece as shown above.

Thread the threaded end of the counterweight

bar into the Dec axis of the equatorial mount.

Before mounting the tube, remove the two

wingnuts on the tub rings.

The focuser end of the telescope should be

over the counterweight assembly.

Locate the finderscope. Remove the knurled

nuts on the threaded posts at the focuser end

of the telescope tube.

For additional magnification, you can use the

included 3x barlow. Place the barlow in the

focuser in place of the eyepiece - remove the

cap from the barlow.

Slide the chrome end of the slow motion

control cables onto equatorial mount gear shaft

and tighten set screw to secure in place.

Place the tube on the mount by lining up the

screws with the mounting holes on the mount.

Loosen the set screw on the focuser so that it

does not obstruct the inner diameter of the

focuser. Remove the plastic cap covering the

end of the focuser.

Orient the finderscope so that the large lens is

facing towards the front of the tube. Place

finderscope over the posts on the tube and

tighten it down with the knurled nuts.

Place the eyepiece into the barlow and tighten

the set screw to secure in place.