HID Signo 40K Manual rápido - Página 3

Procurar online ou descarregar pdf Manual rápido para Leitor de cartões HID Signo 40K. HID Signo 40K 3 páginas. 13.56 mhz/125 khz/2.4 ghz contactless and keypad readers
Também para HID Signo 40K: Manual de instalação (2 páginas)

Imprimir página

Powering

Trusted Identities

Wire the reader

Pigtail version

18" (0.46m)

PIGTAIL

Violet/White

*Dependent upon reader configuration

Note: Wiring the reader incorrectly may permanently damage the reader.

Note: Previous iCLASS® readers had reversed RS-485 wiring (P2-7 & P2-6 - A & B). When upgrading to a HID Signo

reader, ensure proper connections as defined above.

Note: Data 0 and Data 1 wires for Wiegand may be reused for OSDP. However, standard Wiegand cable may not meet

RS485 twisted pair recommendations.

Note: For OSDP cable lengths greater than 200 ft (61 m) or EMF interference, install 120Ω +/- 2Ω resistor across RS-

485 termination ends.

Note: For keypad configuration, with the keypad reader operating as 26 bit emulation, enter the facility code followed

by # within five seconds of power-up. The facility code must be entered as three digits (i.e., for a facility code of 10

enter 0-1-0-#). If unsuccessful, the reader LED displays solid red. Power-cycle the reader and retry entering the facility

code.

HID Signo readers use facility codes between 1-255, and no default is set. Once a facility code is entered, the reader

LED displays violet, then solid red. Then, power-cycle the reader. If there are two short beeps after entering a PIN, the

reader facility code is not configured. In this case, power-cycle the reader and retry entering the facility code.

PLT-03704, Rev. A.3

TERMINAL

Red

Black

White

Green

Orange

Yellow

Blue

Brown

Violet

Bare

—

Terminal Strip version

DESCRIPTION

+VDC

Ground (RTN)

Wiegand Data 1 / Clock / RS485-A*

Wiegand Data 0 / Data / RS485-B*

LED Input (GRN)

Beeper Input

Hold Input / LED Input (BLUE)*

LED Input (RED)

Tamper 2 (RLY2)

Tamper 1 (RLY1)

Drain (pigtail models only)

HID Signo™ Reader Installation Guide

August 2020