Dynalink RTA300 Manual de configuração rápida - Página 13

Procurar online ou descarregar pdf Manual de configuração rápida para Router de rede Dynalink RTA300. Dynalink RTA300 16 páginas. Adsl router

ADSL Router Quick Set-up Guide

If previously you were using a dialup modem, check the browser configuration.

For example in Internet Explorer, go to Tools–Internet options–Connections,

and select Never dial a connection. Also check LAN Settings that the option

Use a Proxy Server is not selected.

If the Router is connected to a network hub, try connecting the Router directly

to the computer in a standalone setup to eliminate any possible hub problems.

If the LAN already has a DHCP server enabled, disable it. Refer to the second

paragraph of Section 4 – Configure your computer in the User's Manual.

Q2. Cannot connect to the Internet or cannot browse.

Check that Router's DSL light is on. Normally it takes less than one minute

to establish an ADSL link. A link will establish as long as there is sufficient

signal. If the DSL light does not come on the Router is not detecting any

signal. Check that:

• The ADSL service has been enabled

• The Router is connected to the correct jackpoint

• The Router is connected directly to a jackpoint, not after a filter or other

device.

Check that Router is on line. Bring up the Quick Start menu of the ADSL

Router Control Panel. Refer to Step 2 – Enter Internet account details of

Section 5 - Going On-Line. If NAT IP shows 0.0.0.0, you are not on line. Make

sure the correct user name and password are entered. The username and

password are provided by your ISP.

Check the configuration of your computer and Router. If you still cannot

browse, perform a PING test as described in Q1-3, using these addresses:

(A) Ping www.dynalink.co.nz (or any valid web address)

(B) Ping 205.178.180.16 (or any valid public IP address)

If both (A) & (B) returned no reply, go to Quick Start and check that NAT is

enabled. Also make sure the Router's firewall is not set to Block. If these

settings are correct, ping the computer's IP address (e.g. ping 192.168.1.2).

If there is still no reply your network card may be faulty.

If (A) returned no reply but (B) showed a reply, this is probably a DNS problem.

Check that you have entered the correct DNS address if this is required by

your ISP.

If both (A) & (B) showed a reply, it could be a problem with your browser

settings. Try returning any custom settings of the browser to default. If you

have personal firewall software running, disable it. Check if the condition in

Q1-5 applies. Finally shut down the computer and restart it.