Gree 26TTW12AC230V1A Manual do Proprietário - Página 12
Procurar online ou descarregar pdf Manual do Proprietário para Ar condicionado Gree 26TTW12AC230V1A. Gree 26TTW12AC230V1A 16 páginas. Ttw
- 1. Table of Contents
- 2. Important Note to Homeowner
- 3. Important Note to Servicer
- 4. Operating Instructions
- 5. Unit Features
- 6. Installation Instructions
- 7. Wiring
- 8. Air Conditioner Features
- 9. Remote Control
- 10. Additional Information
- 11. Normal Operating Sounds and Conditions
- 12. Obtaining Service
- 13. Product Warranty
AIR CONDITIONER FEATURES
N
RESET
FILTER
Note: This feature can be used with any combination of FAN Speeds, Timer . When in the Heat Mode, the
Note: This feature can be used with any combination of FAN speeds, Timer. When in the "Heat" Mode, the fan will run continuously
fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 61 F
while heat is needed. The temperature will automatically be maintained anywhere between 61°F (16°C) and 86°F (30°C). When the
(16 C) and 86 F (30 C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample
room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air.
the room air.
SLEEP FEA
RESET FILTER FEATURE:
N
RESET
FILTER
Note: When this switch is disabled (DOWN), set temperature range will be 61-86°F. When this switch is enabled (UP), set
Note: When this switch is disabled(
temperature range in cooling will be 65-86 F and that in heating will be 61-78
temperature range in cooling will be 65-86°F and that in heating will be 61-78°F. The default setting is DOWN (disabled).
N
RESET
FILTER
S
(continued)
:
RESET FILTER
,set temperature range will be 61-86
DOWN)
:
ON/OFF BUTTON
RESET
FILTER
If the display reads "F1",
If the display reads F1
a sensor has failed.
a sensor has failed.
RESET
FILTER
If the display reads "F4",
If the display reads F4
a sensor has failed.
a sensor has failed.
:
PRESS
MODE BUTTON
SELECT HEAT
PRESS
RESET
FILTER
If the display reads "F2",
If the display reads F2
a sensor has failed.
a sensor has failed.
RESET
FILTER
If the display reads "FJ",
If the display reads FJ
a sensor has failed.
a sensor has failed.
12
N
RESET
FILTER
Y
N
RESET
FILTER
F
. When this switch is enabled
F
. The default setting is DOWN (disabled).
N
RESET
FILTER
:
SEE:
), set
(UP