Gainsborough K901 Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Equipamento de iluminação Gainsborough K901. Gainsborough K901 3 páginas. 2.3m light up maypole tree

Imprimir página

2.3m Light Up Maypole Tree

Please read and retain these instructions for future reference

Allow lamp to charge for at least 8 hours in full sunlight with the ON/OFF switch in the ON position. The

ON/OFF switch is located under the solar panel. Once the batteries are fully charged, set the ON/OFF switch

to ON. If the lamp does not turn on after dark refer to Maintenance section.

There are 8 different modes: Turn switch to "on" position and press MODE button you can achieve the

following light sequences : 1. Combination 2. In wave 3. Sequential 4. Slow Glow 5.Chaser Flashing 6. Slow

Fade 7. Twinkle Flashing 8. Steady On

NOTE: In order to verify that the button is correctly in the "ON " position, cover the solar panel with your

hand and light should turn "ON" automatically.

Find an ideal Place for the Solar Light.

Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of

hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed

in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the

light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from

coming on, or cause it to turn off automatically

To easily insert pole into the ground, it is recommended to wet the ground first. To avoid damaging garden

pole when inserting into the ground, select a spot in soft, rock-free soil. Insert the base of the pole first then

gently insert the rest of the stake into the base. DO NOT push directly against the solar cell or the ornament

housing containing the actual LED light.

MAINTENANCE AND TROUBLESHOOTING:

Make sure the switch is set to "ON" position.

Keep the solar panel clean.

Make sure all connectors are still tight and no water getting in.

If solar product does not light up after it has been used for around 8 – 12 months, replace the

rechargeable batteries as they may be weak or worn out. (Battery 1x AA 1.2v 600Mah, Ni-MH,

Rechargeable– Same equivalent type as recommended must be used).

Battery replacement:

Step1: Unscrew the battery compartment cover by using a Phillips head screwdriver (not included).

Step2: Remove the exhausted battery and install 1x new AA rechargeable battery according to the

+/- polarity as beside image. Open the compartment carefully and ensure that welding wires inside

the battery terminals are not damaged.

Step3: Replace battery compartment cover, screw it back into position and make sure is properly

sealed.

The Enterprise

Department

K901

UK Head Office, 11 Bridge Street, Bishop's Stortford, CM23 2JU

Tel: 0844 4824400*,

Fax: 01279 756595

www.coopersofstortford.co.uk

EU address: D.S.B. LD, 160 Bd. de Fourmies, 59100 Roubaix, France

Tel: (+44) 1279 701269

*UK Calls cost around 7 pence per minute plus your telephone company's network access.

Please check with your telephone supplier.

Instructions for Use

v001: 09/05/22