airdeer A1 Manual de instruções - Página 4
Procurar online ou descarregar pdf Manual de instruções para Mobiliário de exterior airdeer A1. airdeer A1 8 páginas. Automatic trash can
Também para airdeer A1: Manual de instruções (9 páginas)
Imprimir página1.4 Turn the power switch on the back of the trash can from the left side to the right side, that is, from
the OFF position to the ON position. The trash can will load a bag automatically, and then the voice
prompt "Bag loading is complete".
1.5 If the voice prompts: "Failed bag loading, please check if the garbage bag is used up or broken."
please lift the flip lid manually and check whether the garbage bag is broken.
1.5.1 If the garbage bag has a rupture, but the rupture is relatively small, this section of the garbage
bag can still be used. You can manually press the garbage bag to the bottom of the can and continue
to use it.
1.5.2 If the garbage bag rupture is relatively large, this section of the garbage bag cannot be used.
Please manually press the garbage bag to the bottom of the can, and then carry out the operation of
packing and loading the bag again. For details, please refer to Section 4 of the manual "Automatic
Packing and Loading the Bag".
1.5.3 If the garbage bag is not broken after inspection, it is usually because the newly installed refill ring
is too tight, resulting in unsuccessful bag loading. Please manually press the garbage bag to the
bottom of the can and continue to use it. After using several times, the inside of the refill ring becomes
loose, then the bags can be loaded automatically.
1.6 If the voice prompts "Low battery, please charge", please use the attached charging cable to
connect a power adapter with a voltage of 5V and a rated current of 1A or more to charge. When the
battery is low, bag will not be automatically loaded. Please fully charged, then turn on the power
switch to complete automatic bag loading.
2. Infrared sensor flip lid
2.1 In order to achieve a full-coverage flip lid design, this product uses a patented side infrared sensing
technology. When close to the infrared induction port within about 10cm-20cm above, the flip lid will
automatically open, and the flip lid will automatically close after a delay of a few seconds after leaving.
Due to the weak reflection ability, the sensing sensitivity of black or dark-colored objects will be
reduced.
2.2 If the infrared sensing signal exists continuously for more than 5 seconds, the flip lid will enter the
normally open mode and will close only after pressing the touch key.
2.3 Commonly used methods to open the flip lid: one is to take the garbage into the sensing area，
the other is to bend the knee slightly and enter the sensing area.
2.4 Avoid touching the infrared sensor port and keep the infrared sensor port clean. When the infrared
sensor port is dirty, the sensitivity will be reduced, and the flip lid may move by mistake.
3